It’s been a month of ownership. Got some of the trim issues sorted. The driver side rear door trim that
@EricM noted has been replaced and is is now much closer to being properly aligned. (Will never be perfectly aligned but again I’m looking for good enough, not new-car level perfection).
My focus now is on the seating/alignment of the rear glass panel. It seems twisted to the passenger side such that at its front edge it is 5mm closer to the passenger side cantrail than it is to the driver side one. At the rear of the panel, these are reversed — it is 5mm closer to driver side than passenger side.
It is also misaligned vertically. It is a few MM higher than the front panel on the passenger side and a few Mm lower than the from panel on the driver side.
Finally, the gasket between front and back does not appear properly seated and may have gaps.
These issues became apparent after I parked it at SLc airport (interior of parking garage structure) where (despite being undercover) it was covered in dust. Pictures attached but difficult to focus with iPhone camera.
Is this within the vehicle’s tolerances?