Parking camera distortion

[Westchester Air]

Wondering if anyone seems to have a bit of a distortion when using the parking cameras. See pic below for example. As I pull up my narrow driveway the area in front of the car “inverts inward” and sort of straightens out as I approach. It’s a little irritating since I’d like to get close to the driveway curb on the passenger side since that provides more room for me to exit and also gets me closer to my home charger any thoughts here?

 

[borski]

Is it angled? If you have curb rash protection on, it should still trigger near the passenger side curb.

 

[Westchester Air]

Is it angled? If you have curb rash protection on, it should still trigger near the passenger side curb.

No...straight up. Not sure about "curb rash protection". Is that buried in settings?

Should the distortion be there?

 

[californiaboy935]

I’d take it into service; the composited images should be lined up. Most likely this is a calibration problem. I can tell because two walls are displayed in the upper left hand corner.

 

[borski]

I’d take it into service; the composited images should be lined up. Most likely this is a calibration problem. I can tell because two walls are displayed in the upper left hand corner.

View attachment 29525

If it's not angled, it shouldn't be distorted.

And yeah, there's a setting for curb rash protection. It's great. It only works in the daytime or in a well-lit area, though.

 

[californiaboy935]

No...straight up. Not sure about "curb rash protection". Is that buried in settings?

Should the distortion be there?

If it's not angled, it shouldn't be distorted.

And yeah, there's a setting for curb rash protection. It's great. It only works in the daytime or in a well-lit area, though.

Think @Westchester Air said it is “no…[straight up]”. Which I took to mean it’s flat…

 

[Westchester Air]

Think @Westchester Air said it is “no…[straight up]”. Which I took to mean it’s flat…

Yes. Not angled.

 

[borski]

Think @Westchester Air said it is “no…[straight up]”. Which I took to mean it’s flat…

Right. Which is why I said if it’s not angled, aka flat, as I also took it to mean, then it shouldn’t be distorted.

Not sure where the confusion is.

 

[californiaboy935]

Right. Which is why I said if it’s not angled, aka flat, as I also took it to mean, then it shouldn’t be distorted.

Not sure where the confusion is.

I’m confused. Lols.

But I think OP gets the picture…. Albeit a distorted one, until he goes to the service center…