Dreamdrive sensor blocked

Jatin

New Member

Joined
Aug 25, 2026
Messages
5
Reaction score
3
Cars
Gravity touring
The message is popping up today . Is it a common problem, my car was washed yesterday after which drove roughly 160miles with dreamdrive. Any advice?
 
The message is popping up today . Is it a common problem, my car was washed yesterday after which drove roughly 160miles with dreamdrive. Any advice?
Clean all sensors, might have gotten a bug or dirt on them
 
This is what I got the other day;
sensor is blocked
DreamDrive 2 Pro not working
Two red symbols
1 Collision Protection Fault Detected
2 Lane Departure Protection Alert
 
It’s a bug in the software. I get that occasionally, even after I just wash it. Sometimes it won’t clear for the entire drive and other times it’ll go away within a few minutes.
 
This is what I got the other day;
sensor is blocked
DreamDrive 2 Pro not working
Two red symbols
1 Collision Protection Fault Detected
2 Lane Departure Protection Alert
Reboot
 
How about stability control unavailable issue.
Check this thread; no solution but probably give you some ideas on what's next.

 
This is what I got the other day;
sensor is blocked
DreamDrive 2 Pro not working
Two red symbols
1 Collision Protection Fault Detected
2 Lane Departure Protection Alert

I've seen this twice since 3.6.5 was installed. Never before. I don't know whether this is related to the software update or not but thought I'd mention it.
Both times, it cleared up on its own in less that 10 minutes. All sensors were clean.
 
Mine is usually caused by the glass in front of the windshield camera getting fogged up. I turn on the windshield defogger, and it goes away pretty quickly
 
I get it occasionally. Most commonly when driving directly into the sun at dawn or dusk. Confuses the sensors.

But not only then.
 
After installing 3.6.5, I've been getting this every few days. :rolleyes:

It would be a lot more useful if it said which sensor is blocked.

1794853050738.webp
 
It did it again yesterday, but in fairness, I was heading into the sun early in the morning. In this case, I am certain it is sun related, not a software fault.
 
After installing 3.6.5, I've been getting this every few days. :rolleyes:

It would be a lot more useful if it said which sensor is blocked.

View attachment 42405
I got this error yesterday for the first time. A reboot did not help. Sensors were clean and there was no moisture on the windshield camera. Today the car behaved normally after sleeping overnight. I’ve got a long trip planned tomorrow and I don’t want to make it without cruise control.
 
Where are the Sensor(s) which dream drive uses that may be getting blocked?
 
Where are the Sensor(s) which dream drive uses that may be getting blocked?
There’s a diagram of the sensors in the manual.
 
I assume you are talking about the diagrams starting on page 124 of the North American owners manual?
Yes. I did a screen shot of them on my phone and saved the pics to an easy to locate folder. That way I don’t have to dig through the manual every time I want to reference them.
 
I’ve got a long trip planned tomorrow and I don’t want to make it without cruise control.
That's my fear. If this happens on a quick local drive, I don't care. On a road trip, that would really suck.

@marqie there's a clear pattern here. This problem didn't use to happen before 3.6.5.
 
Back
Top