Has anyone removed/ changed their puddle lights? If so, is it a standard plug in?
- Thread starter KingRubin
- Start date
- Joined
- Jan 4, 2022
- Messages
- 5,616
- Reaction score
- 10,714
- Location
- Santa Clarita, CA
- Cars
- 2026 Gravity Dream
- Gravity DE Number
- 68
- Referral Code
- AWNJLGKT
- Joined
- Jan 12, 2025
- Messages
- 215
- Reaction score
- 264
- Cars
- Lucid Air Grand Touring
I have. If I would have known what a pain in the butt it was i probably would have not even attempted it. But it is doable. It just takes a recoding from your mobile service tech.
Each light is coded to each door. So if you pull them out be sure to mark their location.
- Joined
- Jan 12, 2025
- Messages
- 215
- Reaction score
- 264
- Cars
- Lucid Air Grand Touring
No need to pop door panels. You can remove them out with a pocket screwdriver from under the door. If you can't get it from one side switch to the other. Unfortunately the white harness is extremely short so use that same pocket screwdriver to push on the tab to unplug the light.
- Joined
- May 23, 2025
- Messages
- 21
- Reaction score
- 7
- Location
- New Jersey
- Cars
- Lucid Air Touring
- Referral Code
- HFMWFGVZ
I tried to replace the lights in the frunk to see if I could get something brighter in there, popped off the cover and realized it was just a board with an led on it instead of a bulb so I gave up.
- Joined
- Jan 12, 2025
- Messages
- 215
- Reaction score
- 264
- Cars
- Lucid Air Grand Touring
Lucid uses the same lights in the trunk as well as the frunk. Plus the puddle lights in all four doors. They all need to be programmed for their specific location.
Yah they are not very bright and I am not a fan of that amber color. I much prefer the modern LED daytime light. So I was thinking of trying to replace the amber led with a cluster Daytime 6000k Led chip.
I was going to leave the Lucid chip intact but remove just the amber LED from the circuit board and solder in my own. So we will see how that goes.